OnAir

Decode SuperSID (VLF) with an SDR

SuperSID: VLF station levels and the sudden changes of solar flares, receive only.

In the mode list
VLF stations, 15 - 30 kHz

What SuperSID (VLF) is

SuperSID: the strength of the VLF navy transmitters (NAA, NLK, NPM, NWC, DHO38, GQD, HWU, ICV ...) from a VLF-capable radio, one value per 5 s, and a mark when a station jumps within ten minutes: the signature of a solar flare in the lower ionosphere.

Frequencies and settings

OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is VLF stations, 15 - 30 kHz.

What OnAir shows

SuperSID: the strength of the VLF navy transmitters (NAA, NLK, NPM, NWC, DHO38, GQD, HWU, ICV ...) from a VLF-capable radio, one value per 5 s, and a mark when a station jumps within ten minutes: the signature of a solar flare in the lower ionosphere.

Limits and what it was checked with

Checked with generated signals and impairments; recordings of real signals welcome.

Which radio you need

This is a shortwave mode, so the radio has to tune HF. An SDRplay, Airspy HF+ or an RTL-SDR in direct-sampling mode do that directly; with a HackRF an HF upconverter or a direct-sampling receiver is the usual route. A long wire or loop antenna matters more than the radio.

Receiving and the law

Receiving and the law. Receiving these signals is legal in most countries. OnAir is a receiver. See also Legal.

Questions about SuperSID (VLF)

Can I decode SuperSID (VLF) with an RTL-SDR?

An RTL-SDR can receive HF only in direct-sampling mode, which OnAir offers in its radio settings; results depend on the antenna. SDRplay and Airspy HF+ radios are better suited.

Is it legal to receive SuperSID (VLF)?

Receiving these signals is legal in most countries. OnAir is a receiver.

Can I try SuperSID (VLF) in OnAir without a radio?

Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.