OnAir

Decode Landsat 8/9 X-band with an SDR

Landsat 8/9 X-band: X-band direct downlink, needs a dish; recordings.

In the mode list
Landsat 8/9 X-band

What Landsat 8/9 X-band is

Landsat 8 and 9 X-band link: OQPSK 220.4 Msym/s, TIRS channels from decoded .cadu frames. The LDPC 7/8 code from raw IQ is not decoded here. Needs a tracking X-band dish and 240 Msps or more. A recording is the usual way to use it.

Frequencies and settings

OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is Landsat 8/9 X-band.

What OnAir shows

Landsat 8 and 9 X-band link: OQPSK 220.4 Msym/s, TIRS channels from decoded .cadu frames. The LDPC 7/8 code from raw IQ is not decoded here. Needs a tracking X-band dish and 240 Msps or more. A recording is the usual way to use it.

Limits and what it was checked with

Checked with generated signals and impairments; recordings of real signals welcome.

Which radio you need

Any radio that tunes this range works. An RTL-SDR covers roughly 24 MHz to 1.7 GHz, and every other radio in the radio guide reaches it too. Antenna height and a clear view of the transmitter matter most.

Receiving and the law

Receiving and the law. Receiving these signals is legal in most countries. OnAir is a receiver. See also Legal.

Questions about Landsat 8/9 X-band

Can I decode Landsat 8/9 X-band with an RTL-SDR?

Usually yes for narrowband signals, as an RTL-SDR tunes roughly 24 MHz to 1.7 GHz at up to about 2.4 Msps. Wide signals such as TV channels need a faster radio, and OnAir says next to the source what the selected radio can do.

Is it legal to receive Landsat 8/9 X-band?

Receiving these signals is legal in most countries. OnAir is a receiver.

Can I try Landsat 8/9 X-band in OnAir without a radio?

Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.