OnAir

Decode GOES CDA with an SDR

GOES CDA: telemetry frames at 1693 MHz (needs a dish).

In the mode list
GOES CDA telemetry
GitHub wiki
Mode-GOES CDA

What GOES CDA is

GOES CDA telemetry downlink on 1693 / 1694 MHz: GOES-R (40 or 4 kbit/s, BPSK with CCSDS frames) or GOES-N (PM, 4 kbit/s): frame log and virtual channels.

Frequencies and settings

OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is GOES CDA telemetry.

What OnAir shows

GOES CDA telemetry downlink on 1693 / 1694 MHz: GOES-R (40 or 4 kbit/s, BPSK with CCSDS frames) or GOES-N (PM, 4 kbit/s): frame log and virtual channels.

Limits and what it was checked with

Checked with generated signals and impairments; recordings of real signals welcome.

Which radio you need

This mode sits at a high frequency, so check that your radio tunes it: a HackRF covers 1 MHz to 6 GHz, and RTL-SDR stops near 1.7 GHz. Some modes at these frequencies also need a fast radio (10 to 20 Msps) or a dish and an LNB.

Receiving and the law

Receiving and the law. Receiving these signals is legal in most countries. OnAir is a receiver. See also Legal.

Questions about GOES CDA

Can I decode GOES CDA with an RTL-SDR?

Probably not: an RTL-SDR tunes up to about 1.7 GHz. A HackRF (1 MHz to 6 GHz) or another wideband radio is the usual choice for this frequency range.

Is it legal to receive GOES CDA?

Receiving these signals is legal in most countries. OnAir is a receiver.

Can I try GOES CDA in OnAir without a radio?

Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.