OnAir

Decode Proba S-band dump with an SDR

Proba S-band dump: satellite direct downlink, needs a dish; recordings.

In the mode list
Proba S-band dump

What Proba S-band dump is

Proba-1, Proba-2 and Proba-V S-band dump on 2235 MHz: BPSK 2 Msym/s, K=7 r=1/2, CADU frames and the Proba-V Vegetation channels. Needs a tracking S-band dish and 3 Msps. A recording is the usual way to use it.

Frequencies and settings

OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is Proba S-band dump.

What OnAir shows

Proba-1, Proba-2 and Proba-V S-band dump on 2235 MHz: BPSK 2 Msym/s, K=7 r=1/2, CADU frames and the Proba-V Vegetation channels. Needs a tracking S-band dish and 3 Msps. A recording is the usual way to use it.

Limits and what it was checked with

Checked with generated signals and impairments; recordings of real signals welcome.

Which radio you need

This mode sits at a high frequency, so check that your radio tunes it: a HackRF covers 1 MHz to 6 GHz, and RTL-SDR stops near 1.7 GHz. Some modes at these frequencies also need a fast radio (10 to 20 Msps) or a dish and an LNB.

Receiving and the law

Receiving and the law. Receiving these signals is legal in most countries. OnAir is a receiver. See also Legal.

Questions about Proba S-band dump

Can I decode Proba S-band dump with an RTL-SDR?

Probably not: an RTL-SDR tunes up to about 1.7 GHz. A HackRF (1 MHz to 6 GHz) or another wideband radio is the usual choice for this frequency range.

Is it legal to receive Proba S-band dump?

Receiving these signals is legal in most countries. OnAir is a receiver.

Can I try Proba S-band dump in OnAir without a radio?

Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.