OnAir

Decode Saral L-band with an SDR

Saral L-band: satellite direct downlink, needs a dish; recordings.

In the mode list
Saral L-band

What Saral L-band is

Saral Argos link on 1698.4 MHz: QPSK 400 ksym/s, K=7 r=1/2, CADU frames. Needs a tracking L-band dish and 0.6 Msps. A recording is the usual way to use it.

Frequencies and settings

OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is Saral L-band.

What OnAir shows

Saral Argos link on 1698.4 MHz: QPSK 400 ksym/s, K=7 r=1/2, CADU frames. Needs a tracking L-band dish and 0.6 Msps. A recording is the usual way to use it.

Limits and what it was checked with

Checked with generated signals and impairments; recordings of real signals welcome.

Which radio you need

This mode sits at a high frequency, so check that your radio tunes it: a HackRF covers 1 MHz to 6 GHz, and RTL-SDR stops near 1.7 GHz. Some modes at these frequencies also need a fast radio (10 to 20 Msps) or a dish and an LNB.

Receiving and the law

Receiving and the law. Receiving these signals is legal in most countries. OnAir is a receiver. See also Legal.

Questions about Saral L-band

Can I decode Saral L-band with an RTL-SDR?

Probably not: an RTL-SDR tunes up to about 1.7 GHz. A HackRF (1 MHz to 6 GHz) or another wideband radio is the usual choice for this frequency range.

Is it legal to receive Saral L-band?

Receiving these signals is legal in most countries. OnAir is a receiver.

Can I try Saral L-band in OnAir without a radio?

Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.