OnAir

Decode GOES GVAR with an SDR

GOES GVAR: imager broadcast (retired, recordings).

In the mode list
GOES GVAR (recordings)
GitHub wiki
Mode-GOES GVAR

What GOES GVAR is

GOES GVAR, the 2.11 Msym/s BPSK imager broadcast of the GOES-13 to 15 generation on 1685.7 MHz: the imager visible and infrared lines. GOES-N is retired, so this mode opens recordings.

Frequencies and settings

OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is GOES GVAR (recordings).

What OnAir shows

GOES GVAR, the 2.11 Msym/s BPSK imager broadcast of the GOES-13 to 15 generation on 1685.7 MHz: the imager visible and infrared lines. GOES-N is retired, so this mode opens recordings.

Limits and what it was checked with

Checked with generated signals and impairments; recordings of real signals welcome.

Which radio you need

This mode sits at a high frequency, so check that your radio tunes it: a HackRF covers 1 MHz to 6 GHz, and RTL-SDR stops near 1.7 GHz. Some modes at these frequencies also need a fast radio (10 to 20 Msps) or a dish and an LNB.

Receiving and the law

Receiving and the law. Receiving these signals is legal in most countries. OnAir is a receiver. See also Legal.

Questions about GOES GVAR

Can I decode GOES GVAR with an RTL-SDR?

Probably not: an RTL-SDR tunes up to about 1.7 GHz. A HackRF (1 MHz to 6 GHz) or another wideband radio is the usual choice for this frequency range.

Is it legal to receive GOES GVAR?

Receiving these signals is legal in most countries. OnAir is a receiver.

Can I try GOES GVAR in OnAir without a radio?

Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.