Decode AWS L-band with an SDR
AWS: microwave sounder pictures on 1707 MHz (needs a dish).
- Group
- Weather & science
- In the mode list
- AWS MWR, 1.7 GHz
- GitHub wiki
- Mode-AWS L-band
What AWS L-band is
Arctic Weather Satellite on 1707 MHz: QPSK 1.785 Msym/s, CCSDS convolutional code, Reed-Solomon interleave 5, the MWR microwave scans (19 channels, 145 points) line by line. Needs a dish at 1.7 GHz and 4 Msps or more; Follow the next pass tunes with Doppler and starts by itself.
Frequencies and settings
OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is AWS MWR, 1.7 GHz.
What OnAir shows
Arctic Weather Satellite on 1707 MHz: QPSK 1.785 Msym/s, CCSDS convolutional code, Reed-Solomon interleave 5, the MWR microwave scans (19 channels, 145 points) line by line. Needs a dish at 1.7 GHz and 4 Msps or more; Follow the next pass tunes with Doppler and starts by itself.
Limits and what it was checked with
Checked with generated signals and impairments; recordings of real signals welcome.
Which radio you need
This mode sits at a high frequency, so check that your radio tunes it: a HackRF covers 1 MHz to 6 GHz, and RTL-SDR stops near 1.7 GHz. Some modes at these frequencies also need a fast radio (10 to 20 Msps) or a dish and an LNB.
Receiving and the law
Questions about AWS L-band
Can I decode AWS L-band with an RTL-SDR?
Probably not: an RTL-SDR tunes up to about 1.7 GHz. A HackRF (1 MHz to 6 GHz) or another wideband radio is the usual choice for this frequency range.
Is it legal to receive AWS L-band?
Receiving these signals is legal in most countries. OnAir is a receiver.
Can I try AWS L-band in OnAir without a radio?
Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.