OnAir

Decode Throb with an SDR

Throb: two-tone keyboard mode, six variants found automatically, receive only.

In the mode list
Keyboard chat, 14.075 MHz
GitHub wiki
Mode-Throb

What Throb is

Throb and ThrobX (one or two tones at a time out of 9 or 11, symbols of 1, 0.5 or 0.25 s): the tone comb, the variant and the timing are found automatically and the text is printed as it comes.

Frequencies and settings

OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is Keyboard chat, 14.075 MHz.

What OnAir shows

Throb and ThrobX (one or two tones at a time out of 9 or 11, symbols of 1, 0.5 or 0.25 s): the tone comb, the variant and the timing are found automatically and the text is printed as it comes.

Limits and what it was checked with

Checked with generated signals and impairments; recordings of real signals welcome.

Which radio you need

This is a shortwave mode, so the radio has to tune HF. An SDRplay, Airspy HF+ or an RTL-SDR in direct-sampling mode do that directly; with a HackRF an HF upconverter or a direct-sampling receiver is the usual route. A long wire or loop antenna matters more than the radio.

Receiving and the law

Receiving and the law. Amateur radio signals are meant to be received. Receiving needs no licence in most countries; OnAir does not transmit. See also Legal.

Questions about Throb

Can I decode Throb with an RTL-SDR?

An RTL-SDR can receive HF only in direct-sampling mode, which OnAir offers in its radio settings; results depend on the antenna. SDRplay and Airspy HF+ radios are better suited.

Is it legal to receive Throb?

Amateur radio signals are meant to be received. Receiving needs no licence in most countries; OnAir does not transmit.

Can I try Throb in OnAir without a radio?

Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.