OnAir

Decode DFCW grabber with an SDR

DFCW: slow Morse with a frequency for dots and one for dashes, receive only.

In the mode list
Slow CW, 137.5 kHz

What DFCW grabber is

DFCW dual-frequency slow Morse: all elements are the same length, dots on one frequency and dashes on a second one, with a gap between letters. Spectrogram of the keyed tone and the decoded text.

Frequencies and settings

Morse code on the HF bands.

OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is Slow CW, 137.5 kHz.

What OnAir shows

Every CW signal in a 14 kHz window at once: speed, SNR and text, callsigns highlighted.

Limits and what it was checked with

Checked with generated signals and impairments; recordings of real signals welcome.

Which radio you need

This is a shortwave mode, so the radio has to tune HF. An SDRplay, Airspy HF+ or an RTL-SDR in direct-sampling mode do that directly; with a HackRF an HF upconverter or a direct-sampling receiver is the usual route. A long wire or loop antenna matters more than the radio.

Receiving and the law

Receiving and the law. Amateur radio signals are meant to be received. Receiving needs no licence in most countries; OnAir does not transmit. See also Legal.

Questions about DFCW grabber

Can I decode DFCW grabber with an RTL-SDR?

An RTL-SDR can receive HF only in direct-sampling mode, which OnAir offers in its radio settings; results depend on the antenna. SDRplay and Airspy HF+ radios are better suited.

Is it legal to receive DFCW grabber?

Amateur radio signals are meant to be received. Receiving needs no licence in most countries; OnAir does not transmit.

Can I try DFCW grabber in OnAir without a radio?

Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.