OnAir

Decode PI4 with an SDR

PI4: microwave beacon mode, 27 s frames with an 8 character message, receive only.

In the mode list
Microwave beacons, 10 GHz
GitHub wiki
Mode-PI4

What PI4 is

PI4 (PA0NHC, 4-FSK, 146 symbols of 186 ms, a rate 1/2 K = 32 code, 8 characters): the microwave beacon mode of the 10 GHz and 24 GHz bands; sync, frequency and message are found automatically. A converter brings the band to the radio.

Frequencies and settings

OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is Microwave beacons, 10 GHz.

What OnAir shows

PI4 (PA0NHC, 4-FSK, 146 symbols of 186 ms, a rate 1/2 K = 32 code, 8 characters): the microwave beacon mode of the 10 GHz and 24 GHz bands; sync, frequency and message are found automatically. A converter brings the band to the radio.

Limits and what it was checked with

Checked with generated signals and impairments; recordings of real signals welcome.

Which radio you need

This mode sits at a high frequency, so check that your radio tunes it: a HackRF covers 1 MHz to 6 GHz, and RTL-SDR stops near 1.7 GHz. Some modes at these frequencies also need a fast radio (10 to 20 Msps) or a dish and an LNB.

Receiving and the law

Receiving and the law. Amateur radio signals are meant to be received. Receiving needs no licence in most countries; OnAir does not transmit. See also Legal.

Questions about PI4

Can I decode PI4 with an RTL-SDR?

Probably not: an RTL-SDR tunes up to about 1.7 GHz. A HackRF (1 MHz to 6 GHz) or another wideband radio is the usual choice for this frequency range.

Is it legal to receive PI4?

Amateur radio signals are meant to be received. Receiving needs no licence in most countries; OnAir does not transmit.

Can I try PI4 in OnAir without a radio?

Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.