OnAir

Decode Qi wireless charging with an SDR

Qi: packets from the phone to the charger.

In the mode list
Packet

What Qi wireless charging is

Qi wireless chargers (WPC baseline profile, 110 - 205 kHz power signal): what the phone tells the charger by load modulation at 2 kbit/s: signal strength, control error, received power, charge status, end of power transfer, configuration and identification with the manufacturer code. Receive only. Needs a radio that reaches the LF band and a pick-up loop near the charger. Simulated signals only.

Frequencies and settings

OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is Packet.

What OnAir shows

Qi wireless chargers (WPC baseline profile, 110 - 205 kHz power signal): what the phone tells the charger by load modulation at 2 kbit/s: signal strength, control error, received power, charge status, end of power transfer, configuration and identification with the manufacturer code. Receive only. Needs a radio that reaches the LF band and a pick-up loop near the charger. Simulated signals only.

Limits and what it was checked with

Checked with generated signals and impairments; recordings of real signals welcome.

Which radio you need

This is a shortwave mode, so the radio has to tune HF. An SDRplay, Airspy HF+ or an RTL-SDR in direct-sampling mode do that directly; with a HackRF an HF upconverter or a direct-sampling receiver is the usual route. A long wire or loop antenna matters more than the radio.

Receiving and the law

Receiving and the law. This mode is passive. It only receives, never connects, pairs or joins networks, and never decrypts payloads. Check the rules where you live. See also Legal.

Questions about Qi wireless charging

Can I decode Qi wireless charging with an RTL-SDR?

An RTL-SDR can receive HF only in direct-sampling mode, which OnAir offers in its radio settings; results depend on the antenna. SDRplay and Airspy HF+ radios are better suited.

Is it legal to receive Qi wireless charging?

This mode is passive. It only receives, never connects, pairs or joins networks, and never decrypts payloads. Check the rules where you live.

Can I try Qi wireless charging in OnAir without a radio?

Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.