OnAir

Decode OOK / ASK pulse analyser with an SDR

OOK analyser: modulation, bits, timings, repeats.

In the mode list
Event

What OOK / ASK pulse analyser is

OOK / ASK pulse analyser (key fobs, remote switches, sensors, 300 - 920 MHz; like the analyse mode of rtl_433): from the envelope in the 90 kHz around the tuned frequency, the pulse and gap timing, the modulation named (PWM, PPM, Manchester, PCM / NRZ-like), the bits in binary and hex (short = 0, long = 1 is a convention; the real protocol may invert it), the timings in microseconds and the….

Frequencies and settings

OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is Event.

What OnAir shows

OOK / ASK pulse analyser (key fobs, remote switches, sensors, 300 - 920 MHz; like the analyse mode of rtl_433): from the envelope in the 90 kHz around the tuned frequency, the pulse and gap timing, the modulation named (PWM, PPM, Manchester, PCM / NRZ-like), the bits in binary and hex (short = 0, long = 1 is a convention; the real protocol may invert it), the timings in microseconds and the repeats of a frame in a train. Names the pattern, not the product. Simulated signals only.

Limits and what it was checked with

Checked with generated signals and impairments; recordings of real signals welcome.

Which radio you need

This is a shortwave mode, so the radio has to tune HF. An SDRplay, Airspy HF+ or an RTL-SDR in direct-sampling mode do that directly; with a HackRF an HF upconverter or a direct-sampling receiver is the usual route. A long wire or loop antenna matters more than the radio.

Receiving and the law

Receiving and the law. This mode is passive. It only receives, never connects, pairs or joins networks, and never decrypts payloads. Check the rules where you live. See also Legal.

Questions about OOK / ASK pulse analyser

Can I decode OOK / ASK pulse analyser with an RTL-SDR?

An RTL-SDR can receive HF only in direct-sampling mode, which OnAir offers in its radio settings; results depend on the antenna. SDRplay and Airspy HF+ radios are better suited.

Is it legal to receive OOK / ASK pulse analyser?

This mode is passive. It only receives, never connects, pairs or joins networks, and never decrypts payloads. Check the rules where you live.

Can I try OOK / ASK pulse analyser in OnAir without a radio?

Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.