OnAir

Decode ESP-NOW with an SDR

ESP-NOW: ESP8266 / ESP32 packets on a 2.4 GHz Wi-Fi channel, devices and payloads (receive only; needs 20 MHz of bandwidth).

In the mode list
ESP32, 2.4 GHz
GitHub wiki
Mode-ESP-NOW

What ESP-NOW is

ESP-NOW: the packets ESP8266 / ESP32 boards send each other with Espressif's connectionless protocol, on one 2.4 GHz Wi-Fi channel (1 - 14, or auto to hop over them). 802.11 DSSS at 1 Mbit/s (the default) and 2 Mbit/s, OFDM at 6 and 12 Mbit/s; the MAC header, the vendor-specific action frame and the ESP-NOW element (v1 and v2), the payload as hex and text, the FCS. A Devices table (sender….

Frequencies and settings

OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is ESP32, 2.4 GHz.

What OnAir shows

ESP-NOW: the packets ESP8266 / ESP32 boards send each other with Espressif's connectionless protocol, on one 2.4 GHz Wi-Fi channel (1 - 14, or auto to hop over them). 802.11 DSSS at 1 Mbit/s (the default) and 2 Mbit/s, OFDM at 6 and 12 Mbit/s; the MAC header, the vendor-specific action frame and the ESP-NOW element (v1 and v2), the payload as hex and text, the FCS. A Devices table (sender, Espressif address or not, packet rate, level, last payload) and a Messages log. Encrypted packets (CCMP with the user's LMK) are shown as encrypted; a key you enter under Tools > Keys (ESP-NOW) opens yours. Needs a radio with 20 MHz of bandwidth on 2.4 GHz (HackRF, Pluto, LimeSDR, USRP, bladeRF), not an RTL-SDR; 20 Msps works best. Known limit: OFDM frames near the 1470-byte maximum can be lost when the sender's clock runs 25 ppm fast. Receive only.

Limits and what it was checked with

Checked with generated signals and impairments; recordings of real signals welcome.

Which radio you need

This mode sits at a high frequency, so check that your radio tunes it: a HackRF covers 1 MHz to 6 GHz, and RTL-SDR stops near 1.7 GHz. Some modes at these frequencies also need a fast radio (10 to 20 Msps) or a dish and an LNB.

Receiving and the law

Receiving and the law. This mode is passive. It only receives, never connects, pairs or joins networks, and never decrypts payloads. Check the rules where you live. See also Legal.

Questions about ESP-NOW

Can I decode ESP-NOW with an RTL-SDR?

Probably not: an RTL-SDR tunes up to about 1.7 GHz. A HackRF (1 MHz to 6 GHz) or another wideband radio is the usual choice for this frequency range.

Is it legal to receive ESP-NOW?

This mode is passive. It only receives, never connects, pairs or joins networks, and never decrypts payloads. Check the rules where you live.

Can I try ESP-NOW in OnAir without a radio?

Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.