OnAir

Decode nRF24L01 (needs a user test) with an SDR

NRF24L01: Enhanced ShockBurst frames of mice, sensors and remotes on one 2.4 GHz channel (needs a 2.4 GHz SDR).

In the mode list
2.4 GHz, channel 0-125

What nRF24L01 (needs a user test) is

NRF24L01 / nRF24L01+ Enhanced ShockBurst sniffer, receive only and untested on air (no real recording was available): 2.4 GHz channel N = 2400 + N MHz (N = 0..125), GFSK at 250 kbit/s, 1 and 2 Mbit/s tried together, frames with a 3 to 5 byte address, 9-bit control field (length, PID, NO_ACK), up to 32 payload bytes and CRC-8 or CRC-16. The address is found by trying the candidate positions and….

Frequencies and settings

OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is 2.4 GHz, channel 0-125.

What OnAir shows

nRF24L01 / nRF24L01+ Enhanced ShockBurst sniffer, receive only and untested on air (no real recording was available): 2.4 GHz channel N = 2400 + N MHz (N = 0..125), GFSK at 250 kbit/s, 1 and 2 Mbit/s tried together, frames with a 3 to 5 byte address, 9-bit control field (length, PID, NO_ACK), up to 32 payload bytes and CRC-8 or CRC-16. The address is found by trying the candidate positions and lengths and accepting a valid CRC; a CRC-8 frame is shown when seen three times. Needs a 2.4 GHz SDR: HackRF One / Pro, PlutoSDR (extended range), bladeRF, LimeSDR, USRP B200 / B210; RTL-SDR, Airspy R2 / Mini and SDRplay do not reach 2.4 GHz.

Limits and what it was checked with

Checked with generated signals and impairments; recordings of real signals welcome.

Which radio you need

This mode sits at a high frequency, so check that your radio tunes it: a HackRF covers 1 MHz to 6 GHz, and RTL-SDR stops near 1.7 GHz. Some modes at these frequencies also need a fast radio (10 to 20 Msps) or a dish and an LNB.

Receiving and the law

Receiving and the law. This mode is passive. It only receives, never connects, pairs or joins networks, and never decrypts payloads. Check the rules where you live. See also Legal.

Questions about nRF24L01 (needs a user test)

Can I decode nRF24L01 (needs a user test) with an RTL-SDR?

Probably not: an RTL-SDR tunes up to about 1.7 GHz. A HackRF (1 MHz to 6 GHz) or another wideband radio is the usual choice for this frequency range.

Is it legal to receive nRF24L01 (needs a user test)?

This mode is passive. It only receives, never connects, pairs or joins networks, and never decrypts payloads. Check the rules where you live.

Can I try nRF24L01 (needs a user test) in OnAir without a radio?

Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.