Decode FlySky RC (AFHDS / 2A) with an SDR
FlySky AFHDS / AFHDS 2A: 2.4 GHz RC link monitor, receive only. Needs a 2.4 GHz SDR.
- Group
- IoT & sensors
- Start frequency
- 2440 MHz
- In the mode list
- RC link
- GitHub wiki
- Mode-FlySky RC (AFHDS / 2A)
What FlySky RC (AFHDS / 2A) is
FlySky AFHDS and AFHDS 2A 2.4 GHz RC links (A7105 GFSK, hopping): transmitter id and channels; layouts from the DIY-Multiprotocol-TX-Module project, simulated signals only so far.
Frequencies and settings
| Start frequency | 2440 MHz |
|---|
OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is RC link.
What OnAir shows
FlySky AFHDS and AFHDS 2A 2.4 GHz RC links (A7105 GFSK, hopping): transmitter id and channels; layouts from the DIY-Multiprotocol-TX-Module project, simulated signals only so far.
Limits and what it was checked with
Checked with generated signals and impairments; recordings of real signals welcome.
Which radio you need
This mode sits at a high frequency, so check that your radio tunes it: a HackRF covers 1 MHz to 6 GHz, and RTL-SDR stops near 1.7 GHz. Some modes at these frequencies also need a fast radio (10 to 20 Msps) or a dish and an LNB.
Receiving and the law
Questions about FlySky RC (AFHDS / 2A)
Can I decode FlySky RC (AFHDS / 2A) with an RTL-SDR?
Probably not: an RTL-SDR tunes up to about 1.7 GHz. A HackRF (1 MHz to 6 GHz) or another wideband radio is the usual choice for this frequency range.
Is it legal to receive FlySky RC (AFHDS / 2A)?
This mode is passive. It only receives, never connects, pairs or joins networks, and never decrypts payloads. Check the rules where you live.
Can I try FlySky RC (AFHDS / 2A) in OnAir without a radio?
Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.