Decode MAVLink (SiK radio) with an SDR
MAVLink over SiK telemetry radios (ArduPilot, PX4). Receive only. A wider capture covers more hop channels.
- Group
- IoT & sensors
- Start frequency
- 433.92 MHz
- In the mode list
- Drone telemetry
- GitHub wiki
- Mode-MAVLink (SiK radio)
What MAVLink (SiK radio) is
MAVLink telemetry on SiK / 3DR radios at 433 and 915 MHz: GFSK frequency hopping, every air speed, MAVLink v1 / v2 messages with vehicle position on the map.
Frequencies and settings
| Start frequency | 433.92 MHz |
|---|
OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is Drone telemetry.
What OnAir shows
MAVLink telemetry on SiK / 3DR radios at 433 and 915 MHz: GFSK frequency hopping, every air speed, MAVLink v1 / v2 messages with vehicle position on the map.
Limits and what it was checked with
Checked with generated signals and impairments; recordings of real signals welcome.
Which radio you need
Any radio that tunes this range works. An RTL-SDR covers roughly 24 MHz to 1.7 GHz, and every other radio in the radio guide reaches it too. Antenna height and a clear view of the transmitter matter most.
Receiving and the law
Questions about MAVLink (SiK radio)
Can I decode MAVLink (SiK radio) with an RTL-SDR?
Usually yes for narrowband signals, as an RTL-SDR tunes roughly 24 MHz to 1.7 GHz at up to about 2.4 Msps. Wide signals such as TV channels need a faster radio, and OnAir says next to the source what the selected radio can do.
Is it legal to receive MAVLink (SiK radio)?
This mode is passive. It only receives, never connects, pairs or joins networks, and never decrypts payloads. Check the rules where you live.
Can I try MAVLink (SiK radio) in OnAir without a radio?
Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.