Decode Futaba RC (S-FHSS) with an SDR
Futaba S-FHSS: 2.4 GHz RC link monitor, receive only. Needs a 2.4 GHz SDR.
- Group
- IoT & sensors
- Start frequency
- 2440 MHz
- In the mode list
- RC link
- GitHub wiki
- Mode-Futaba RC (S-FHSS)
What Futaba RC (S-FHSS) is
Futaba S-FHSS 2.4 GHz RC links (CC2500 2-FSK 128 kbit/s, 30 hop channels): transmitter id, hop code and the four channel values of each packet; layout from the DIY-Multiprotocol-TX-Module project, simulated signals only so far. FASST is not decodable (no public description).
Frequencies and settings
| Start frequency | 2440 MHz |
|---|
OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is RC link.
What OnAir shows
Futaba S-FHSS 2.4 GHz RC links (CC2500 2-FSK 128 kbit/s, 30 hop channels): transmitter id, hop code and the four channel values of each packet; layout from the DIY-Multiprotocol-TX-Module project, simulated signals only so far. FASST is not decodable (no public description).
Limits and what it was checked with
Checked with generated signals and impairments; recordings of real signals welcome.
Which radio you need
This mode sits at a high frequency, so check that your radio tunes it: a HackRF covers 1 MHz to 6 GHz, and RTL-SDR stops near 1.7 GHz. Some modes at these frequencies also need a fast radio (10 to 20 Msps) or a dish and an LNB.
Receiving and the law
Questions about Futaba RC (S-FHSS)
Can I decode Futaba RC (S-FHSS) with an RTL-SDR?
Probably not: an RTL-SDR tunes up to about 1.7 GHz. A HackRF (1 MHz to 6 GHz) or another wideband radio is the usual choice for this frequency range.
Is it legal to receive Futaba RC (S-FHSS)?
This mode is passive. It only receives, never connects, pairs or joins networks, and never decrypts payloads. Check the rules where you live.
Can I try Futaba RC (S-FHSS) in OnAir without a radio?
Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.