Decode SCADA radio telemetry (Modbus, DNP3) with an SDR
SCADA telemetry: Modbus RTU and DNP3 over utility data radios (receive only; check local law; simulated only).
- Group
- IoT & sensors
- In the mode list
- Utility telemetry
- GitHub wiki
- Mode-SCADA radio telemetry (Modbus, DNP3)
What SCADA radio telemetry (Modbus, DNP3) is
Licensed utility and pipeline data radios (450 MHz, 900 MHz, the US MAS band 928 / 952 MHz): Bell 202 or V.23 audio FSK at 1200 baud on an FM channel, or direct 2-FSK / 4-FSK at 4800, 9600 and 19200 bit/s, found by itself with its baud rate and deviation; async 8N1 / 8E1 / 8O1 bytes or HDLC framing. Reads Modbus RTU (address, function, registers and values, exceptions, CRC) and DNP3 (link layer….
Frequencies and settings
OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is Utility telemetry.
What OnAir shows
Licensed utility and pipeline data radios (450 MHz, 900 MHz, the US MAS band 928 / 952 MHz): Bell 202 or V.23 audio FSK at 1200 baud on an FM channel, or direct 2-FSK / 4-FSK at 4800, 9600 and 19200 bit/s, found by itself with its baud rate and deviation; async 8N1 / 8E1 / 8O1 bytes or HDLC framing. Reads Modbus RTU (address, function, registers and values, exceptions, CRC) and DNP3 (link layer with its CRCs, transport, application: function, objects, IIN flags, class polls, unsolicited responses, time sync), pairs each request with its response and lists the masters and outstations with the registers and points seen. Unknown, proprietary or encrypted frames (DNP3 Secure Authentication, MDS or MOSCAD framing) are shown raw, never guessed. Export to CSV and JSON. Receive only: listening to non-broadcast utility traffic may be restricted in some countries; check local law. Not verified on a live signal (simulated signals only).
Limits and what it was checked with
Checked with generated signals and impairments; recordings of real signals welcome.
Which radio you need
Any radio that tunes this range works. An RTL-SDR covers roughly 24 MHz to 1.7 GHz, and every other radio in the radio guide reaches it too. Antenna height and a clear view of the transmitter matter most.
Receiving and the law
Questions about SCADA radio telemetry (Modbus, DNP3)
Can I decode SCADA radio telemetry (Modbus, DNP3) with an RTL-SDR?
Usually yes for narrowband signals, as an RTL-SDR tunes roughly 24 MHz to 1.7 GHz at up to about 2.4 Msps. Wide signals such as TV channels need a faster radio, and OnAir says next to the source what the selected radio can do.
Is it legal to receive SCADA radio telemetry (Modbus, DNP3)?
This mode is passive. It only receives, never connects, pairs or joins networks, and never decrypts payloads. Check the rules where you live.
Can I try SCADA radio telemetry (Modbus, DNP3) in OnAir without a radio?
Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.