Decode EM4100 LF RFID (125 kHz) with an SDR
EM4100 tags: ID and modulation depth.
- Group
- IoT & sensors
- In the mode list
- Tag
- GitHub wiki
- Mode-EM4100 LF RFID (125 kHz)
What EM4100 LF RFID (125 kHz) is
EM4100 / EM4102 125 kHz RFID tags in the field of a reader: the 40-bit ID (version and 32-bit number) from the load modulation of the carrier, with the modulation depth. RF/64 and RF/32. Receive only, nothing is written to or copied from a tag. Needs a radio that reaches 125 kHz (direct sampling or an LF capable SDR) and a coil or loop near the reader. Simulated signals only.
Frequencies and settings
OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is Tag.
What OnAir shows
EM4100 / EM4102 125 kHz RFID tags in the field of a reader: the 40-bit ID (version and 32-bit number) from the load modulation of the carrier, with the modulation depth. RF/64 and RF/32. Receive only, nothing is written to or copied from a tag. Needs a radio that reaches 125 kHz (direct sampling or an LF capable SDR) and a coil or loop near the reader. Simulated signals only.
Limits and what it was checked with
Checked with generated signals and impairments; recordings of real signals welcome.
Which radio you need
This is a shortwave mode, so the radio has to tune HF. An SDRplay, Airspy HF+ or an RTL-SDR in direct-sampling mode do that directly; with a HackRF an HF upconverter or a direct-sampling receiver is the usual route. A long wire or loop antenna matters more than the radio.
Receiving and the law
Questions about EM4100 LF RFID (125 kHz)
Can I decode EM4100 LF RFID (125 kHz) with an RTL-SDR?
An RTL-SDR can receive HF only in direct-sampling mode, which OnAir offers in its radio settings; results depend on the antenna. SDRplay and Airspy HF+ radios are better suited.
Is it legal to receive EM4100 LF RFID (125 kHz)?
This mode is passive. It only receives, never connects, pairs or joins networks, and never decrypts payloads. Check the rules where you live.
Can I try EM4100 LF RFID (125 kHz) in OnAir without a radio?
Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.