Decode ExpressLRS with an SDR
ExpressLRS: open-source RC link. Receive only. Tune the middle of the hop plan (EU868 866.4 MHz) with a wide sample rate.
- Group
- IoT & sensors
- Start frequency
- 866.425 MHz
- In the mode list
- RC link, structure only
- GitHub wiki
- Mode-ExpressLRS
What ExpressLRS is
ExpressLRS RC links on the 900 MHz LoRa rates: link id, rate and hop index from SYNC frames; RC channels only with your own binding phrase (Advanced). 2.4 GHz FLRC and long-interleaver LoRa are not decodable.
Frequencies and settings
| Start frequency | 866.425 MHz |
|---|
OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is RC link, structure only.
What OnAir shows
ExpressLRS RC links on the 900 MHz LoRa rates: link id, rate and hop index from SYNC frames; RC channels only with your own binding phrase (Advanced). 2.4 GHz FLRC and long-interleaver LoRa are not decodable.
Limits and what it was checked with
Checked with generated signals and impairments; recordings of real signals welcome.
Which radio you need
This mode sits at a high frequency, so check that your radio tunes it: a HackRF covers 1 MHz to 6 GHz, and RTL-SDR stops near 1.7 GHz. Some modes at these frequencies also need a fast radio (10 to 20 Msps) or a dish and an LNB.
Receiving and the law
Questions about ExpressLRS
Can I decode ExpressLRS with an RTL-SDR?
Probably not: an RTL-SDR tunes up to about 1.7 GHz. A HackRF (1 MHz to 6 GHz) or another wideband radio is the usual choice for this frequency range.
Is it legal to receive ExpressLRS?
This mode is passive. It only receives, never connects, pairs or joins networks, and never decrypts payloads. Check the rules where you live.
Can I try ExpressLRS in OnAir without a radio?
Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.