Decode FM modulation monitor with an SDR
FM monitor: deviation, pilot, RDS, MPX power.
- Group
- Broadcast radio
- In the mode list
- Event
- GitHub wiki
- Mode-FM modulation monitor
What FM modulation monitor is
FM broadcast modulation monitor: peak and RMS deviation, MPX power, carrier offset, the 19 kHz pilot and stereo, the 57 kHz RDS injection, SCA subcarriers and the audio level of a station, with over-deviation logged. A reading of what arrives, not a type-approval instrument. Simulated signals only.
Frequencies and settings
OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is Event.
What OnAir shows
FM broadcast modulation monitor: peak and RMS deviation, MPX power, carrier offset, the 19 kHz pilot and stereo, the 57 kHz RDS injection, SCA subcarriers and the audio level of a station, with over-deviation logged. A reading of what arrives, not a type-approval instrument. Simulated signals only.
Limits and what it was checked with
Checked with generated signals and impairments; recordings of real signals welcome.
Which radio you need
This is a shortwave mode, so the radio has to tune HF. An SDRplay, Airspy HF+ or an RTL-SDR in direct-sampling mode do that directly; with a HackRF an HF upconverter or a direct-sampling receiver is the usual route. A long wire or loop antenna matters more than the radio.
Receiving and the law
Questions about FM modulation monitor
Can I decode FM modulation monitor with an RTL-SDR?
An RTL-SDR can receive HF only in direct-sampling mode, which OnAir offers in its radio settings; results depend on the antenna. SDRplay and Airspy HF+ radios are better suited.
Is it legal to receive FM modulation monitor?
Receiving broadcast radio is legal in most countries. OnAir cannot decode encrypted services.
Can I try FM modulation monitor in OnAir without a radio?
Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.