OnAir

Decode STL link (studio-to-transmitter) with an SDR

STL link: composite or mono analogue studio-to-transmitter audio (simulated only).

In the mode list
Stereo and RDS

What STL link (studio-to-transmitter) is

Analogue studio-to-transmitter links of broadcast radio (US Part 74 band 944 - 952 MHz, similar bands elsewhere): FM carrying the station's whole stereo composite (19 kHz pilot, stereo difference, RDS, SCA) at about +-60 kHz deviation in a 250 or 500 kHz channel, or mono programme audio. Plays the sound with a stereo decoder, 75 / 50 microsecond de-emphasis, adjustable deviation and channel….

Frequencies and settings

OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is Stereo and RDS.

What OnAir shows

Analogue studio-to-transmitter links of broadcast radio (US Part 74 band 944 - 952 MHz, similar bands elsewhere): FM carrying the station's whole stereo composite (19 kHz pilot, stereo difference, RDS, SCA) at about +-60 kHz deviation in a 250 or 500 kHz channel, or mono programme audio. Plays the sound with a stereo decoder, 75 / 50 microsecond de-emphasis, adjustable deviation and channel width, level meters, RDS and SCA listening, and says what it hears: composite, mono, or a digital link (Moseley Starlink, Intraplex and similar: QAM or OFDM with PCM or AAC, often encrypted) which is named and measured but not decoded. Unencrypted analogue links only; receive only. Simulated signals only.

Limits and what it was checked with

Checked with generated signals and impairments; recordings of real signals welcome.

Which radio you need

This is a shortwave mode, so the radio has to tune HF. An SDRplay, Airspy HF+ or an RTL-SDR in direct-sampling mode do that directly; with a HackRF an HF upconverter or a direct-sampling receiver is the usual route. A long wire or loop antenna matters more than the radio.

Receiving and the law

Receiving and the law. Receiving broadcast radio is legal in most countries. OnAir cannot decode encrypted services. See also Legal.

Questions about STL link (studio-to-transmitter)

Can I decode STL link (studio-to-transmitter) with an RTL-SDR?

An RTL-SDR can receive HF only in direct-sampling mode, which OnAir offers in its radio settings; results depend on the antenna. SDRplay and Airspy HF+ radios are better suited.

Is it legal to receive STL link (studio-to-transmitter)?

Receiving broadcast radio is legal in most countries. OnAir cannot decode encrypted services.

Can I try STL link (studio-to-transmitter) in OnAir without a radio?

Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.