OnAir

Decode UHF SATCOM skimmer with an SDR

Active channels on UHF military satellites (detection only).

In the mode list
Satellite carriers

What UHF SATCOM skimmer is

Skims 240 - 270 MHz military satellite downlinks for active channels (5 and 25 kHz): frequency, width, activity. Detection only.

Frequencies and settings

OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is Satellite carriers.

What OnAir shows

Skims 240 - 270 MHz military satellite downlinks for active channels (5 and 25 kHz): frequency, width, activity. Detection only.

Limits and what it was checked with

Checked with generated signals and impairments; recordings of real signals welcome.

Which radio you need

This is a shortwave mode, so the radio has to tune HF. An SDRplay, Airspy HF+ or an RTL-SDR in direct-sampling mode do that directly; with a HackRF an HF upconverter or a direct-sampling receiver is the usual route. A long wire or loop antenna matters more than the radio.

Receiving and the law

Receiving and the law. Receiving satellite downlinks is generally legal. Encrypted or spread content is not decoded, and voice codecs that are patented are not shipped with OnAir. See also Legal.

Questions about UHF SATCOM skimmer

Can I decode UHF SATCOM skimmer with an RTL-SDR?

An RTL-SDR can receive HF only in direct-sampling mode, which OnAir offers in its radio settings; results depend on the antenna. SDRplay and Airspy HF+ radios are better suited.

Is it legal to receive UHF SATCOM skimmer?

Receiving satellite downlinks is generally legal. Encrypted or spread content is not decoded, and voice codecs that are patented are not shipped with OnAir.

Can I try UHF SATCOM skimmer in OnAir without a radio?

Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.