OnAir

Decode GNSS interference detector with an SDR

GNSS interference: class, level, sweep.

In the mode list
Interference

What GNSS interference detector is

GNSS interference detector (L1 1575.42 MHz, L2 1227.6 MHz and others, needs a radio with a few MHz of bandwidth and a GNSS antenna): says whether a navigation band is clean, or holds a tone, narrowband interference, a swept chirp (a car jammer: range, period, rate) or wideband noise, and how strong it is. Detects and describes only; no position is computed. Simulated signals only.

Frequencies and settings

GPS L1.

OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is Interference.

What OnAir shows

Satellites, position and time; Clock tab: UTC and GPS time, leap seconds (and a pending one), the computer clock offset against the satellites (accuracy limited by USB / SDR latency, 5 - 30 ms), level, C/N0 and offset history, the same *Sync computer clock* section and optional NTP server as the Time signals mode.

Limits and what it was checked with

Checked with generated signals and impairments; recordings of real signals welcome.

Which radio you need

This mode sits at a high frequency, so check that your radio tunes it: a HackRF covers 1 MHz to 6 GHz, and RTL-SDR stops near 1.7 GHz. Some modes at these frequencies also need a fast radio (10 to 20 Msps) or a dish and an LNB.

Receiving and the law

Receiving and the law. Receiving satellite downlinks is generally legal. Encrypted or spread content is not decoded, and voice codecs that are patented are not shipped with OnAir. See also Legal.

Questions about GNSS interference detector

Can I decode GNSS interference detector with an RTL-SDR?

Probably not: an RTL-SDR tunes up to about 1.7 GHz. A HackRF (1 MHz to 6 GHz) or another wideband radio is the usual choice for this frequency range.

Is it legal to receive GNSS interference detector?

Receiving satellite downlinks is generally legal. Encrypted or spread content is not decoded, and voice codecs that are patented are not shipped with OnAir.

Can I try GNSS interference detector in OnAir without a radio?

Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.