Decode PACTOR-III with an SDR
PACTOR-III: HF multi-carrier D-PSK, carrier set and frame structure (physical layer only; no text).
- Group
- HF utility
- In the mode list
- HF ARQ, multi-carrier
- GitHub wiki
- Mode-PACTOR-III
What PACTOR-III is
PACTOR-III, receive only, physical layer: 2 to 18 D-PSK carriers on the 120 Hz grid 480 + 120 n Hz at 100 baud, the carrier set (speed level) and the repeating frame structure. The channel coding is proprietary (SCS) and not published, so no text is produced.
Frequencies and settings
OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is HF ARQ, multi-carrier.
What OnAir shows
PACTOR-III, receive only, physical layer: 2 to 18 D-PSK carriers on the 120 Hz grid 480 + 120 n Hz at 100 baud, the carrier set (speed level) and the repeating frame structure. The channel coding is proprietary (SCS) and not published, so no text is produced.
Limits and what it was checked with
Checked with generated signals and impairments; recordings of real signals welcome.
Which radio you need
This is a shortwave mode, so the radio has to tune HF. An SDRplay, Airspy HF+ or an RTL-SDR in direct-sampling mode do that directly; with a HackRF an HF upconverter or a direct-sampling receiver is the usual route. A long wire or loop antenna matters more than the radio.
Receiving and the law
Questions about PACTOR-III
Can I decode PACTOR-III with an RTL-SDR?
An RTL-SDR can receive HF only in direct-sampling mode, which OnAir offers in its radio settings; results depend on the antenna. SDRplay and Airspy HF+ radios are better suited.
Is it legal to receive PACTOR-III?
Some HF utility traffic belongs to governments or the military. Receiving is legal in many countries, but rules differ. Check them where you live.
Can I try PACTOR-III in OnAir without a radio?
Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.