Decode CIS-36 (MFSK) with an SDR
CIS-36 MFSK: identification only (simulated only).
- Group
- HF utility
- In the mode list
- Identification only, HF
- GitHub wiki
- Mode-CIS-36 (MFSK)
What CIS-36 (MFSK) is
CIS-36 MFSK duplex ARQ, identification only: the tone count, the 40 Hz spacing, the 10 / 20 / 40 Bd tone rate and the tone groups are measured and the signal named. No frame format is published. Simulated signals only so far.
Frequencies and settings
OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is Identification only, HF.
What OnAir shows
CIS-36 MFSK duplex ARQ, identification only: the tone count, the 40 Hz spacing, the 10 / 20 / 40 Bd tone rate and the tone groups are measured and the signal named. No frame format is published. Simulated signals only so far.
Limits and what it was checked with
Checked with generated signals and impairments; recordings of real signals welcome.
Which radio you need
This is a shortwave mode, so the radio has to tune HF. An SDRplay, Airspy HF+ or an RTL-SDR in direct-sampling mode do that directly; with a HackRF an HF upconverter or a direct-sampling receiver is the usual route. A long wire or loop antenna matters more than the radio.
Receiving and the law
Questions about CIS-36 (MFSK)
Can I decode CIS-36 (MFSK) with an RTL-SDR?
An RTL-SDR can receive HF only in direct-sampling mode, which OnAir offers in its radio settings; results depend on the antenna. SDRplay and Airspy HF+ radios are better suited.
Is it legal to receive CIS-36 (MFSK)?
Some HF utility traffic belongs to governments or the military. Receiving is legal in many countries, but rules differ. Check them where you live.
Can I try CIS-36 (MFSK) in OnAir without a radio?
Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.