Decode EFR teleswitch with an SDR
EFR: DCF49 / DCF39 radio teleswitch telegrams (simulated signals only).
- Group
- HF utility
- In the mode list
- LF telegrams, FSK
- GitHub wiki
- Mode-EFR teleswitch
What EFR teleswitch is
EFR radio teleswitching, receive only: DCF49 (129.1 kHz) and DCF39 (139 kHz), 200 Bd FSK, DIN 19244 frames with message number, addresses and checksum. Semagyr and Versacom content stays as hex. Tested on simulated signals.
Frequencies and settings
OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is LF telegrams, FSK.
What OnAir shows
EFR radio teleswitching, receive only: DCF49 (129.1 kHz) and DCF39 (139 kHz), 200 Bd FSK, DIN 19244 frames with message number, addresses and checksum. Semagyr and Versacom content stays as hex. Tested on simulated signals.
Limits and what it was checked with
Checked with generated signals and impairments; recordings of real signals welcome.
Which radio you need
This is a shortwave mode, so the radio has to tune HF. An SDRplay, Airspy HF+ or an RTL-SDR in direct-sampling mode do that directly; with a HackRF an HF upconverter or a direct-sampling receiver is the usual route. A long wire or loop antenna matters more than the radio.
Receiving and the law
Questions about EFR teleswitch
Can I decode EFR teleswitch with an RTL-SDR?
An RTL-SDR can receive HF only in direct-sampling mode, which OnAir offers in its radio settings; results depend on the antenna. SDRplay and Airspy HF+ radios are better suited.
Is it legal to receive EFR teleswitch?
Some HF utility traffic belongs to governments or the military. Receiving is legal in many countries, but rules differ. Check them where you live.
Can I try EFR teleswitch in OnAir without a radio?
Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.