Decode MIL-STD-188-110 serial with an SDR
MIL-STD-188-110: serial tone HF data modem with STANAG 5066 framing (simulated signals only).
- Group
- HF utility
- In the mode list
- HF data modem, 8-PSK
- GitHub wiki
- Mode-MIL-STD-188-110 serial
What MIL-STD-188-110 serial is
MIL-STD-188-110A/C fixed-frequency serial tone modem, receive only: 2400 Bd 8-PSK on 1800 Hz, 75 to 4800 bit/s. The preamble gives speed and interleaver, then probes, deinterleaver and Viterbi decoding, with STANAG 5066 D_PDU framing when present. Tested on simulated signals.
Frequencies and settings
Approach guidance, 75 / 108 - 112 / 329 - 335 MHz.
OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is HF data modem, 8-PSK.
What OnAir shows
Localizer and glide slope needles (DDM), marker beacons, identification.
Limits and what it was checked with
Checked with generated signals and impairments; recordings of real signals welcome.
Which radio you need
This is a shortwave mode, so the radio has to tune HF. An SDRplay, Airspy HF+ or an RTL-SDR in direct-sampling mode do that directly; with a HackRF an HF upconverter or a direct-sampling receiver is the usual route. A long wire or loop antenna matters more than the radio.
Receiving and the law
Questions about MIL-STD-188-110 serial
Can I decode MIL-STD-188-110 serial with an RTL-SDR?
An RTL-SDR can receive HF only in direct-sampling mode, which OnAir offers in its radio settings; results depend on the antenna. SDRplay and Airspy HF+ radios are better suited.
Is it legal to receive MIL-STD-188-110 serial?
Some HF utility traffic belongs to governments or the military. Receiving is legal in many countries, but rules differ. Check them where you live.
Can I try MIL-STD-188-110 serial in OnAir without a radio?
Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.