OnAir

Decode G-TOR with an SDR

G-TOR: HF ARQ monitor (simulated signals only).

In the mode list
HF ARQ, FSK
GitHub wiki
Mode-G-TOR

What G-TOR is

G-TOR monitor, receive only: 100, 200, 300 Bd frames with Golay coding and CRC, data and Golay forms both read. ASCII frames show text; Huffman frames stay as hex. Tested on simulated signals.

Frequencies and settings

OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is HF ARQ, FSK.

What OnAir shows

G-TOR monitor, receive only: 100, 200, 300 Bd frames with Golay coding and CRC, data and Golay forms both read. ASCII frames show text; Huffman frames stay as hex. Tested on simulated signals.

Limits and what it was checked with

Checked with generated signals and impairments; recordings of real signals welcome.

Which radio you need

This is a shortwave mode, so the radio has to tune HF. An SDRplay, Airspy HF+ or an RTL-SDR in direct-sampling mode do that directly; with a HackRF an HF upconverter or a direct-sampling receiver is the usual route. A long wire or loop antenna matters more than the radio.

Receiving and the law

Receiving and the law. Some HF utility traffic belongs to governments or the military. Receiving is legal in many countries, but rules differ. Check them where you live. See also Legal.

Questions about G-TOR

Can I decode G-TOR with an RTL-SDR?

An RTL-SDR can receive HF only in direct-sampling mode, which OnAir offers in its radio settings; results depend on the antenna. SDRplay and Airspy HF+ radios are better suited.

Is it legal to receive G-TOR?

Some HF utility traffic belongs to governments or the military. Receiving is legal in many countries, but rules differ. Check them where you live.

Can I try G-TOR in OnAir without a radio?

Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.