Decode ARQ-N with an SDR
ARQ-N: HF duplex ARQ teleprinter (simulated signals only).
- Group
- HF utility
- In the mode list
- HF ARQ, FSK
- GitHub wiki
- Mode-ARQ-N
What ARQ-N is
ARQ-N, receive only: as ARQ-E without inverted characters. Tested on simulated signals.
Frequencies and settings
OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is HF ARQ, FSK.
What OnAir shows
ARQ-N, receive only: as ARQ-E without inverted characters. Tested on simulated signals.
Limits and what it was checked with
Checked with generated signals and impairments; recordings of real signals welcome.
Which radio you need
This is a shortwave mode, so the radio has to tune HF. An SDRplay, Airspy HF+ or an RTL-SDR in direct-sampling mode do that directly; with a HackRF an HF upconverter or a direct-sampling receiver is the usual route. A long wire or loop antenna matters more than the radio.
Receiving and the law
Questions about ARQ-N
Can I decode ARQ-N with an RTL-SDR?
An RTL-SDR can receive HF only in direct-sampling mode, which OnAir offers in its radio settings; results depend on the antenna. SDRplay and Airspy HF+ radios are better suited.
Is it legal to receive ARQ-N?
Some HF utility traffic belongs to governments or the military. Receiving is legal in many countries, but rules differ. Check them where you live.
Can I try ARQ-N in OnAir without a radio?
Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.