Decode CIS-128 with an SDR
CIS-128: identification only (simulated only).
- Group
- HF utility
- In the mode list
- Identification only, HF
- GitHub wiki
- Mode-CIS-128
What CIS-128 is
CIS-128, identification only: about 128 OFDM carriers at about 21 Bd in 3 kHz, from the carrier spacing, the symbol rate and the guard. The 6 kHz form is not covered. No frame format is published. Simulated signals only so far.
Frequencies and settings
OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is Identification only, HF.
What OnAir shows
CIS-128, identification only: about 128 OFDM carriers at about 21 Bd in 3 kHz, from the carrier spacing, the symbol rate and the guard. The 6 kHz form is not covered. No frame format is published. Simulated signals only so far.
Limits and what it was checked with
Checked with generated signals and impairments; recordings of real signals welcome.
Which radio you need
This is a shortwave mode, so the radio has to tune HF. An SDRplay, Airspy HF+ or an RTL-SDR in direct-sampling mode do that directly; with a HackRF an HF upconverter or a direct-sampling receiver is the usual route. A long wire or loop antenna matters more than the radio.
Receiving and the law
Questions about CIS-128
Can I decode CIS-128 with an RTL-SDR?
An RTL-SDR can receive HF only in direct-sampling mode, which OnAir offers in its radio settings; results depend on the antenna. SDRplay and Airspy HF+ radios are better suited.
Is it legal to receive CIS-128?
Some HF utility traffic belongs to governments or the military. Receiving is legal in many countries, but rules differ. Check them where you live.
Can I try CIS-128 in OnAir without a radio?
Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.