Decode CIS-14 with an SDR
CIS-14: 96 Bd FSK, 14-bit frames shown raw (receive only, simulated only).
- Group
- HF utility
- In the mode list
- HF FSK, 96 Bd
- GitHub wiki
- Mode-CIS-14
What CIS-14 is
CIS-14 (AMOR, AMOR96) 2-FSK at 96 Bd, receive only: the 14-bit frame is found from its period and every frame's fields are shown raw (2 state bits, two 5-bit code words, 2 parity bits). The parity rule and the state codes are not published, so they are shown, not checked. Simulated signals only so far.
Frequencies and settings
OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is HF FSK, 96 Bd.
What OnAir shows
CIS-14 (AMOR, AMOR96) 2-FSK at 96 Bd, receive only: the 14-bit frame is found from its period and every frame's fields are shown raw (2 state bits, two 5-bit code words, 2 parity bits). The parity rule and the state codes are not published, so they are shown, not checked. Simulated signals only so far.
Limits and what it was checked with
Checked with generated signals and impairments; recordings of real signals welcome.
Which radio you need
This is a shortwave mode, so the radio has to tune HF. An SDRplay, Airspy HF+ or an RTL-SDR in direct-sampling mode do that directly; with a HackRF an HF upconverter or a direct-sampling receiver is the usual route. A long wire or loop antenna matters more than the radio.
Receiving and the law
Questions about CIS-14
Can I decode CIS-14 with an RTL-SDR?
An RTL-SDR can receive HF only in direct-sampling mode, which OnAir offers in its radio settings; results depend on the antenna. SDRplay and Airspy HF+ radios are better suited.
Is it legal to receive CIS-14?
Some HF utility traffic belongs to governments or the military. Receiving is legal in many countries, but rules differ. Check them where you live.
Can I try CIS-14 in OnAir without a radio?
Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.