OnAir

Decode Coquelet-8 with an SDR

Coquelet-8: HF MFSK teleprinter (simulated signals only).

In the mode list
HF MFSK
GitHub wiki
Mode-Coquelet-8

What Coquelet-8 is

Coquelet-8 MFSK, receive only: ITA2 by tone pairs (8 tones, 26.67 Hz spacing), 37.5, 50 or 75 ms tones found automatically. Tested on simulated signals.

Frequencies and settings

OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is HF MFSK.

What OnAir shows

Coquelet-8 MFSK, receive only: ITA2 by tone pairs (8 tones, 26.67 Hz spacing), 37.5, 50 or 75 ms tones found automatically. Tested on simulated signals.

Limits and what it was checked with

Checked with generated signals and impairments; recordings of real signals welcome.

Which radio you need

This is a shortwave mode, so the radio has to tune HF. An SDRplay, Airspy HF+ or an RTL-SDR in direct-sampling mode do that directly; with a HackRF an HF upconverter or a direct-sampling receiver is the usual route. A long wire or loop antenna matters more than the radio.

Receiving and the law

Receiving and the law. Some HF utility traffic belongs to governments or the military. Receiving is legal in many countries, but rules differ. Check them where you live. See also Legal.

Questions about Coquelet-8

Can I decode Coquelet-8 with an RTL-SDR?

An RTL-SDR can receive HF only in direct-sampling mode, which OnAir offers in its radio settings; results depend on the antenna. SDRplay and Airspy HF+ radios are better suited.

Is it legal to receive Coquelet-8?

Some HF utility traffic belongs to governments or the military. Receiving is legal in many countries, but rules differ. Check them where you live.

Can I try Coquelet-8 in OnAir without a radio?

Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.