OnAir

Decode CIS-3000 with an SDR

CIS-3000: identification only (simulated only).

In the mode list
Identification only, HF
GitHub wiki
Mode-CIS-3000

What CIS-3000 is

CIS-3000, identification only: a single carrier 8-PSK at 3000 Bd, from its symbol-rate line and the constellation order. No frame format is published. Simulated signals only so far.

Frequencies and settings

OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is Identification only, HF.

What OnAir shows

CIS-3000, identification only: a single carrier 8-PSK at 3000 Bd, from its symbol-rate line and the constellation order. No frame format is published. Simulated signals only so far.

Limits and what it was checked with

Checked with generated signals and impairments; recordings of real signals welcome.

Which radio you need

This is a shortwave mode, so the radio has to tune HF. An SDRplay, Airspy HF+ or an RTL-SDR in direct-sampling mode do that directly; with a HackRF an HF upconverter or a direct-sampling receiver is the usual route. A long wire or loop antenna matters more than the radio.

Receiving and the law

Receiving and the law. Some HF utility traffic belongs to governments or the military. Receiving is legal in many countries, but rules differ. Check them where you live. See also Legal.

Questions about CIS-3000

Can I decode CIS-3000 with an RTL-SDR?

An RTL-SDR can receive HF only in direct-sampling mode, which OnAir offers in its radio settings; results depend on the antenna. SDRplay and Airspy HF+ radios are better suited.

Is it legal to receive CIS-3000?

Some HF utility traffic belongs to governments or the military. Receiving is legal in many countries, but rules differ. Check them where you live.

Can I try CIS-3000 in OnAir without a radio?

Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.