Decode Power-line noise locator with an SDR
Noise locator: impulse rate, repetition, level.
- Group
- General & tools
- In the mode list
- Pattern
- GitHub wiki
- Mode-Power-line noise locator
What Power-line noise locator is
Power-line and impulse noise analyser: finds the impulses in a band and measures their rate and level, and tells a repetition at twice the mains frequency (100 / 120 Hz, an arcing insulator or a faulty lamp) from a half-wave one (50 / 60 Hz), a steady switching supply and random static. For hunting the source of interference with an antenna in hand. Simulated signals only.
Frequencies and settings
OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is Pattern.
What OnAir shows
Power-line and impulse noise analyser: finds the impulses in a band and measures their rate and level, and tells a repetition at twice the mains frequency (100 / 120 Hz, an arcing insulator or a faulty lamp) from a half-wave one (50 / 60 Hz), a steady switching supply and random static. For hunting the source of interference with an antenna in hand. Simulated signals only.
Limits and what it was checked with
Checked with generated signals and impairments; recordings of real signals welcome.
Which radio you need
Any radio that tunes this range works. An RTL-SDR covers roughly 24 MHz to 1.7 GHz, and every other radio in the radio guide reaches it too. Antenna height and a clear view of the transmitter matter most.
Receiving and the law
Questions about Power-line noise locator
Can I decode Power-line noise locator with an RTL-SDR?
Usually yes for narrowband signals, as an RTL-SDR tunes roughly 24 MHz to 1.7 GHz at up to about 2.4 Msps. Wide signals such as TV channels need a faster radio, and OnAir says next to the source what the selected radio can do.
Is it legal to receive Power-line noise locator?
These tools only look at the spectrum and listen. Receiving is legal in most countries, but laws differ on what you may use the content for.
Can I try Power-line noise locator in OnAir without a radio?
Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.