Decode Noise figure (Y-factor) meter with an SDR
Noise figure: Y-factor, NF for the source ENR.
- Group
- General & tools
- In the mode list
- Event
- GitHub wiki
- Mode-Noise figure (Y-factor) meter
What Noise figure (Y-factor) meter is
Noise figure (Y-factor) meter: switch a noise source on and off in front of the receiver and read the step in the middle 200 kHz of the capture: Y in dB, and the receiver noise figure NF = ENR - 10 log(Y - 1) for the common source values (ENR 5, 6.5, 15, 25 dB; read the line for your source). Needs fixed gain (no AGC) and only noise in the band. Simulated signals only.
Frequencies and settings
OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is Event.
What OnAir shows
Noise figure (Y-factor) meter: switch a noise source on and off in front of the receiver and read the step in the middle 200 kHz of the capture: Y in dB, and the receiver noise figure NF = ENR - 10 log(Y - 1) for the common source values (ENR 5, 6.5, 15, 25 dB; read the line for your source). Needs fixed gain (no AGC) and only noise in the band. Simulated signals only.
Limits and what it was checked with
Checked with generated signals and impairments; recordings of real signals welcome.
Which radio you need
This is a shortwave mode, so the radio has to tune HF. An SDRplay, Airspy HF+ or an RTL-SDR in direct-sampling mode do that directly; with a HackRF an HF upconverter or a direct-sampling receiver is the usual route. A long wire or loop antenna matters more than the radio.
Receiving and the law
Questions about Noise figure (Y-factor) meter
Can I decode Noise figure (Y-factor) meter with an RTL-SDR?
An RTL-SDR can receive HF only in direct-sampling mode, which OnAir offers in its radio settings; results depend on the antenna. SDRplay and Airspy HF+ radios are better suited.
Is it legal to receive Noise figure (Y-factor) meter?
These tools only look at the spectrum and listen. Receiving is legal in most countries, but laws differ on what you may use the content for.
Can I try Noise figure (Y-factor) meter in OnAir without a radio?
Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.