OnAir

Decode Modulation quality (MER) meter with an SDR

MER meter: modulation, symbol rate, MER, EVM.

In the mode list
Event

What Modulation quality (MER) meter is

Modulation quality meter: the MER and EVM of a BPSK, QPSK or 8-PSK carrier found blind (symbol rate, order, carrier offset, roll-off), 300 baud to about 40 kBd in the default 250 ksps channel. Hard decisions: below about 8 dB MER the number reads too good. QAM, APSK, FSK and OFDM are not measured. Simulated signals only.

Frequencies and settings

OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is Event.

What OnAir shows

Modulation quality meter: the MER and EVM of a BPSK, QPSK or 8-PSK carrier found blind (symbol rate, order, carrier offset, roll-off), 300 baud to about 40 kBd in the default 250 ksps channel. Hard decisions: below about 8 dB MER the number reads too good. QAM, APSK, FSK and OFDM are not measured. Simulated signals only.

Limits and what it was checked with

Checked with generated signals and impairments; recordings of real signals welcome.

Which radio you need

Any radio that tunes this range works. An RTL-SDR covers roughly 24 MHz to 1.7 GHz, and every other radio in the radio guide reaches it too. Antenna height and a clear view of the transmitter matter most.

Receiving and the law

Receiving and the law. These tools only look at the spectrum and listen. Receiving is legal in most countries, but laws differ on what you may use the content for. See also Legal.

Questions about Modulation quality (MER) meter

Can I decode Modulation quality (MER) meter with an RTL-SDR?

Usually yes for narrowband signals, as an RTL-SDR tunes roughly 24 MHz to 1.7 GHz at up to about 2.4 Msps. Wide signals such as TV channels need a faster radio, and OnAir says next to the source what the selected radio can do.

Is it legal to receive Modulation quality (MER) meter?

These tools only look at the spectrum and listen. Receiving is legal in most countries, but laws differ on what you may use the content for.

Can I try Modulation quality (MER) meter in OnAir without a radio?

Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.