Decode Mode Builder with an SDR
Mode Builder: decoders built from a description, and the custom modes you registered.
- Group
- General & tools
- In the mode list
- Custom decoders
- GitHub wiki
- Mode-Mode Builder
What Mode Builder is
Mode Builder: describe a digital protocol (modulation, sync word, frame, FEC, CRC, fields) and decode it without code; your custom modes are listed here.
Frequencies and settings
OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is Custom decoders.
What OnAir shows
Mode Builder: describe a digital protocol (modulation, sync word, frame, FEC, CRC, fields) and decode it without code; your custom modes are listed here.
Limits and what it was checked with
Checked with generated signals and impairments; recordings of real signals welcome.
Which radio you need
Any radio that tunes this range works. An RTL-SDR covers roughly 24 MHz to 1.7 GHz, and every other radio in the radio guide reaches it too. Antenna height and a clear view of the transmitter matter most.
Receiving and the law
Questions about Mode Builder
Can I decode Mode Builder with an RTL-SDR?
Usually yes for narrowband signals, as an RTL-SDR tunes roughly 24 MHz to 1.7 GHz at up to about 2.4 Msps. Wide signals such as TV channels need a faster radio, and OnAir says next to the source what the selected radio can do.
Is it legal to receive Mode Builder?
These tools only look at the spectrum and listen. Receiving is legal in most countries, but laws differ on what you may use the content for.
Can I try Mode Builder in OnAir without a radio?
Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.