Decode Phase noise meter with an SDR
Phase noise: L(f), spurs, jitter.
- Group
- General & tools
- In the mode list
- Event
- GitHub wiki
- Mode-Phase noise meter
What Phase noise meter is
Phase noise meter: the single-sideband phase noise of a carrier (a generator, an oscillator, a beacon) in dBc/Hz at 10 Hz to 100 kHz offsets, the spurs next to it and the integrated jitter, from averaged high-resolution spectra. The radio's own oscillator and noise floor are part of the reading: tuning a good source on a poor SDR measures the SDR. Simulated signals only.
Frequencies and settings
OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is Event.
What OnAir shows
Phase noise meter: the single-sideband phase noise of a carrier (a generator, an oscillator, a beacon) in dBc/Hz at 10 Hz to 100 kHz offsets, the spurs next to it and the integrated jitter, from averaged high-resolution spectra. The radio's own oscillator and noise floor are part of the reading: tuning a good source on a poor SDR measures the SDR. Simulated signals only.
Limits and what it was checked with
Checked with generated signals and impairments; recordings of real signals welcome.
Which radio you need
This is a shortwave mode, so the radio has to tune HF. An SDRplay, Airspy HF+ or an RTL-SDR in direct-sampling mode do that directly; with a HackRF an HF upconverter or a direct-sampling receiver is the usual route. A long wire or loop antenna matters more than the radio.
Receiving and the law
Questions about Phase noise meter
Can I decode Phase noise meter with an RTL-SDR?
An RTL-SDR can receive HF only in direct-sampling mode, which OnAir offers in its radio settings; results depend on the antenna. SDRplay and Airspy HF+ radios are better suited.
Is it legal to receive Phase noise meter?
These tools only look at the spectrum and listen. Receiving is legal in most countries, but laws differ on what you may use the content for.
Can I try Phase noise meter in OnAir without a radio?
Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.