Decode TETRA DMO with an SDR
TETRA Direct Mode: DSB and DNB bursts, DM-SETUP and the calls.
- Group
- Two-way radio
- In the mode list
- Direct Mode
- GitHub wiki
- Mode-TETRA DMO
What TETRA DMO is
TETRA Direct Mode (terminal to terminal, or through a DM repeater or gateway): the addresses, the calls and clear speech (with the user-installed TETRA codec); encrypted calls are listed, not decoded.
Frequencies and settings
TETRA base station broadcast (ETSI EN 300 392-2: BSCH, BNCH, AACH, MCCH), 25 kHz channels.
OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is Direct Mode.
What OnAir shows
Network code, colour code, location area, carriers and duplex spacing, services, neighbour cells, whether encryption is used; scan over a span; receive only, nothing decrypted.
Limits and what it was checked with
Checked with generated signals and impairments; recordings of real signals welcome.
Which radio you need
This is a shortwave mode, so the radio has to tune HF. An SDRplay, Airspy HF+ or an RTL-SDR in direct-sampling mode do that directly; with a HackRF an HF upconverter or a direct-sampling receiver is the usual route. A long wire or loop antenna matters more than the radio.
Receiving and the law
Questions about TETRA DMO
Can I decode TETRA DMO with an RTL-SDR?
An RTL-SDR can receive HF only in direct-sampling mode, which OnAir offers in its radio settings; results depend on the antenna. SDRplay and Airspy HF+ radios are better suited.
Is it legal to receive TETRA DMO?
In many countries it is illegal to intercept or disclose private radio communications. OnAir is a receiver: encrypted calls show up only as encrypted and are never decrypted, and voice needs a library you install yourself. Follow the law where you live.
Can I try TETRA DMO in OnAir without a radio?
Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.