OnAir

Decode Kenwood FleetSync with an SDR

Kenwood FleetSync: fleet and unit number of each burst, with the carrier it came on (receive only).

In the mode list
1200 bit/s burst on FM

What Kenwood FleetSync is

Kenwood FleetSync unit ID bursts on analog FM: every FM carrier of the span is followed and the 1200 bit/s FFSK data burst at the start of a transmission is decoded (FleetSync and FleetSync II). Fleet and unit number are shown; the message type, status and position bits are shown as raw words, their layout is not published.

Frequencies and settings

OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is 1200 bit/s burst on FM.

What OnAir shows

Kenwood FleetSync unit ID bursts on analog FM: every FM carrier of the span is followed and the 1200 bit/s FFSK data burst at the start of a transmission is decoded (FleetSync and FleetSync II). Fleet and unit number are shown; the message type, status and position bits are shown as raw words, their layout is not published.

Limits and what it was checked with

Checked with generated signals and impairments; recordings of real signals welcome.

Which radio you need

Any radio that tunes this range works. An RTL-SDR covers roughly 24 MHz to 1.7 GHz, and every other radio in the radio guide reaches it too. Antenna height and a clear view of the transmitter matter most.

Receiving and the law

Receiving and the law. In many countries it is illegal to intercept or disclose private radio communications. OnAir is a receiver: encrypted calls show up only as encrypted and are never decrypted, and voice needs a library you install yourself. Follow the law where you live. See also Legal.

Questions about Kenwood FleetSync

Can I decode Kenwood FleetSync with an RTL-SDR?

Usually yes for narrowband signals, as an RTL-SDR tunes roughly 24 MHz to 1.7 GHz at up to about 2.4 Msps. Wide signals such as TV channels need a faster radio, and OnAir says next to the source what the selected radio can do.

Is it legal to receive Kenwood FleetSync?

In many countries it is illegal to intercept or disclose private radio communications. OnAir is a receiver: encrypted calls show up only as encrypted and are never decrypted, and voice needs a library you install yourself. Follow the law where you live.

Can I try Kenwood FleetSync in OnAir without a radio?

Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.