Decode EDACS trunking with an SDR
EDACS trunking: control channel frames, calls and analog voice following of a trunked system.
- Group
- Two-way radio
- In the mode list
- 9600 bit/s control channel
- GitHub wiki
- Mode-EDACS trunking
What EDACS trunking is
EDACS is an analog trunking system with a 9600 bit/s GFSK control channel. OnAir shows the control frames only; the data words are shown raw. In development.
Frequencies and settings
OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is 9600 bit/s control channel.
What OnAir shows
EDACS control channel, 9600 bit/s GFSK: the outbound frames framed by the dotting, three copies voted, the 12 BCH check bits verified, the Barker sync word, and the calls, talkgroups and site read in the Standard / Networked layout (or Extended Addressing), a power scan of the voice channels of a frequency table you enter, and following of an analog voice channel in a wide capture. No ProVoice (digital voice) decoding, nothing encrypted (receive only).
Limits and what it was checked with
In development: tested on generated signals with simulated noise only, never on the air. Recordings welcome.
Which radio you need
Any radio that tunes this range works. An RTL-SDR covers roughly 24 MHz to 1.7 GHz, and every other radio in the radio guide reaches it too. Antenna height and a clear view of the transmitter matter most.
Receiving and the law
Questions about EDACS trunking
Can I decode EDACS trunking with an RTL-SDR?
Usually yes for narrowband signals, as an RTL-SDR tunes roughly 24 MHz to 1.7 GHz at up to about 2.4 Msps. Wide signals such as TV channels need a faster radio, and OnAir says next to the source what the selected radio can do.
Is it legal to receive EDACS trunking?
In many countries it is illegal to intercept or disclose private radio communications. OnAir is a receiver: encrypted calls show up only as encrypted and are never decrypted, and voice needs a library you install yourself. Follow the law where you live.
Can I try EDACS trunking in OnAir without a radio?
Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.