Decode VDL3 with an SDR
VDL Mode 3: management, voice and data bursts on a 25 kHz VHF channel, receive only.
What VDL3 is
VDL Mode 3: TDMA D8PSK voice and data link on 118 to 137 MHz (ICAO Annex 10; trialled, never deployed; synthetic + spec; receive only). Burst kinds, Golay and Reed-Solomon checked, data octets; the system data and headers as raw values (ICAO Doc 9805 is not public), voice not decoded.
Frequencies and settings
OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is TDMA link, 25 kHz.
What OnAir shows
VDL Mode 3: TDMA D8PSK voice and data link on 118 to 137 MHz (ICAO Annex 10; trialled, never deployed; synthetic + spec; receive only). Burst kinds, Golay and Reed-Solomon checked, data octets; the system data and headers as raw values (ICAO Doc 9805 is not public), voice not decoded.
Limits and what it was checked with
Checked with generated signals and impairments; recordings of real signals welcome.
Which radio you need
This is a shortwave mode, so the radio has to tune HF. An SDRplay, Airspy HF+ or an RTL-SDR in direct-sampling mode do that directly; with a HackRF an HF upconverter or a direct-sampling receiver is the usual route. A long wire or loop antenna matters more than the radio.
Receiving and the law
Questions about VDL3
Can I decode VDL3 with an RTL-SDR?
An RTL-SDR can receive HF only in direct-sampling mode, which OnAir offers in its radio settings; results depend on the antenna. SDRplay and Airspy HF+ radios are better suited.
Is it legal to receive VDL3?
Receiving aircraft broadcasts is legal in many countries, but some restrict listening to or using what you hear. OnAir is a receiver. Check the rules where you live.
Can I try VDL3 in OnAir without a radio?
Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.