OnAir

Decode ERMES paging with an SDR

ERMES: European paging on 169 MHz.

Group
Pagers
In the mode list
Pagers, 169 MHz

What ERMES paging is

ERMES (ETS 300 133) pan-European paging, 169.4 - 169.8 MHz, 4-level FM at 6250 bit/s: network identity, addresses, and numeric or text messages. Tune one 25 kHz channel. Receive only.

Frequencies and settings

OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is Pagers, 169 MHz.

What OnAir shows

ERMES (ETS 300 133) pan-European paging, 169.4 - 169.8 MHz, 4-level FM at 6250 bit/s: network identity, addresses, and numeric or text messages. Tune one 25 kHz channel. Receive only.

Limits and what it was checked with

Checked with generated signals and impairments; recordings of real signals welcome.

Which radio you need

This is a shortwave mode, so the radio has to tune HF. An SDRplay, Airspy HF+ or an RTL-SDR in direct-sampling mode do that directly; with a HackRF an HF upconverter or a direct-sampling receiver is the usual route. A long wire or loop antenna matters more than the radio.

Receiving and the law

Receiving and the law. Pager messages can contain private information, and some countries restrict listening to them. Check the rules where you live before you use this mode. See also Legal.

Questions about ERMES paging

Can I decode ERMES paging with an RTL-SDR?

An RTL-SDR can receive HF only in direct-sampling mode, which OnAir offers in its radio settings; results depend on the antenna. SDRplay and Airspy HF+ radios are better suited.

Is it legal to receive ERMES paging?

Pager messages can contain private information, and some countries restrict listening to them. Check the rules where you live before you use this mode.

Can I try ERMES paging in OnAir without a radio?

Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.