OnAir

Decode Yaesu Fusion with an SDR

Yaesu Fusion: source / destination callsigns, repeater, call mode and slow data (voice only with a codec you install).

In the mode list
C4FM digital voice, 2 m and 70 cm

What Yaesu Fusion is

Yaesu System Fusion is a C4FM digital voice system (4800 symbols/s, 12.5 kHz) on 2 m and 70 cm. OnAir decodes callsigns, call mode and slow data. The voice needs a speech codec plug-in (id ysf) that you install yourself. In development.

Frequencies and settings

OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is C4FM digital voice, 2 m and 70 cm.

What OnAir shows

Yaesu System Fusion (C4FM 4800 symbols/s, 12.5 kHz), 2 m and 70 cm. Receive only: callsigns, call mode and slow data are decoded (the frames are bit-identical to what MMDVMHost writes); V/D mode 1 voice plays through the mbelib you install for DMR and NXDN, the other voice types need a speech codec plug-in that you install yourself.

Limits and what it was checked with

In development: tested on generated signals with simulated noise only, never on the air. Recordings welcome.

Which radio you need

This is a shortwave mode, so the radio has to tune HF. An SDRplay, Airspy HF+ or an RTL-SDR in direct-sampling mode do that directly; with a HackRF an HF upconverter or a direct-sampling receiver is the usual route. A long wire or loop antenna matters more than the radio.

Receiving and the law

Receiving and the law. Amateur radio signals are meant to be received. Receiving needs no licence in most countries; OnAir does not transmit. Voice needs a codec library you install yourself. See also Legal.

Questions about Yaesu Fusion

Can I decode Yaesu Fusion with an RTL-SDR?

An RTL-SDR can receive HF only in direct-sampling mode, which OnAir offers in its radio settings; results depend on the antenna. SDRplay and Airspy HF+ radios are better suited.

Is it legal to receive Yaesu Fusion?

Amateur radio signals are meant to be received. Receiving needs no licence in most countries; OnAir does not transmit. Voice needs a codec library you install yourself.

Can I try Yaesu Fusion in OnAir without a radio?

Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.