OnAir

Decode HF packet 300 Bd with an SDR

HF packet 300 Bd: AX.25 frames, full decode (simulated only).

In the mode list
AX.25, upper sideband, HF

What HF packet 300 Bd is

HF packet radio, full decode: AX.25 frames in 300 Bd AFSK (tones 1600 and 1800 Hz, 200 Hz shift) on the upper sideband, with NRZI, bit stuffing and CRC-16. Each good frame is shown as sender>destination,path:text, and a tuning error of up to a quarter of the shift is followed. Simulated signals only so far.

Frequencies and settings

OnAir takes any frequency you type; the numbers above are the mode's starting point and the range its table describes. In the app the shortcut label is AX.25, upper sideband, HF.

What OnAir shows

HF packet radio, full decode: AX.25 frames in 300 Bd AFSK (tones 1600 and 1800 Hz, 200 Hz shift) on the upper sideband, with NRZI, bit stuffing and CRC-16. Each good frame is shown as sender>destination,path:text, and a tuning error of up to a quarter of the shift is followed. Simulated signals only so far.

Limits and what it was checked with

Checked with generated signals and impairments; recordings of real signals welcome.

Which radio you need

This is a shortwave mode, so the radio has to tune HF. An SDRplay, Airspy HF+ or an RTL-SDR in direct-sampling mode do that directly; with a HackRF an HF upconverter or a direct-sampling receiver is the usual route. A long wire or loop antenna matters more than the radio.

Receiving and the law

Receiving and the law. Amateur radio signals are meant to be received. Receiving needs no licence in most countries; OnAir does not transmit. Voice needs a codec library you install yourself. See also Legal.

Questions about HF packet 300 Bd

Can I decode HF packet 300 Bd with an RTL-SDR?

An RTL-SDR can receive HF only in direct-sampling mode, which OnAir offers in its radio settings; results depend on the antenna. SDRplay and Airspy HF+ radios are better suited.

Is it legal to receive HF packet 300 Bd?

Amateur radio signals are meant to be received. Receiving needs no licence in most countries; OnAir does not transmit. Voice needs a codec library you install yourself.

Can I try HF packet 300 Bd in OnAir without a radio?

Yes. Most modes include a built-in synthetic test signal, so you can open the screen and try the controls before you own a radio.